DOOR/WINDOW SENSOR Model 2WA9 PRELIMINARY COPY
1. INTRODUCTION
The water sensor model 2WA9 is designed to detect the water overflow, water leakage or rising
water such as the water level of your bathtub. When water is detected, the receiver will alert you.
It will beep and flash.
In this package, you should find a sensor and mounting accessories.
Please follow the instructions below to setup the door/window sensor.
2. INSTALLATION
i)
Remove the top cover of the sensor and insert one AA battery (sold separate) to the sensor
as shown in the diagram.
ii) After inserting the battery to the water sensor, press and hold the learn button in the receiver
unit, release the button when the receiver emits a beep.The corresponding zone red LED on
the receiver will flash.
iii) You can test the water sensor by submerging the sensor portion in water. Note: Only the
sensor portion of the water sensor is waterproof, the transmitter portion should never be
submerged in water.
iv) When the sensor portion becomes submerged in water, the receiver unit will emit a long beep
indicating it has learned the code from the sensor.
MOUNTING LOCATION
A clean smooth surface is required to mount the water sensor securely. Mount the transmitter
portion and sensor portion to the appropriate location with suction cups respectively.
OPERATION
When the sensor portion detects water overflow, water leakage, or rising water, the receiver will
beep and the corresponding zone red LED light will flash.
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.