Skyhawk miniSensor, Быстрый старт

Страница: 6 / 24

5
Device Status Lights
Powering On (Valid Hub Connection)
Event Trigger
On & Active Status
Device Reset
Powering Down
Powering On (Failed Hub Connection)
Blink Pause Rapid Flashing
(10 Sec.)
(5 Sec.)
(Every 10 Sec. Normal)
(5 Sec.)
NOTE: If the Sensor is out of range or the Hub unit was not turned on, the status LED on the Sensor
will start rapidly blinking red after power up. Make sure the Hub unit was turned ON first or try
relocating the Sensor/Hub combination so they are closer to each other. Power cycle or reset Sensor
to retry Hub unit connectivity validation. (For further troubleshooting refer to hardware user manual)
(5 Sec.)
(Every 10 Sec. Retransmission)