Assembly and Operating Manual
11
Fig. 40
and
41
-
Checking Ailerons and Elevators
-
Check that the control surfaces respond to the appropriate
movements of the transmitter sticks. If not, swap over the
connectors at the receiver.
-
Make sure do not apply glue to control rods fastener
before check the neutral position of the control surfaces
-
Stand behind the model.
-
Check the direction of rotation of the servos:
-
Move the aileron stick to the right (a), and the right aileron (a)
must rise up, the left aileron (b) fall down.
-
Pull the elevator stick back towards you (c), and the trailing
edge of both elevators should rise (c).
-
If either function works in the wrong way, correct it using your
transmitter’s servo reverse facility for that channel.
Fig. 42 - Checking the power system
- Hold the model securely.
- Remove any loose objects such as cloths, tools, etc from the
area in front of the model, as they could easily be sucked into
the ducted fan.
- Open the throttle (stick forward): the motor should now run,
and you should feel a strong air flow rushing out from the tail
end of the model.
- Move the throttle stick back to the “Motor OFF” position.
- Disconnect the battery from the electronic speed controller
and then switch the transmitter off.
41
40
42
