LiPo BATTERY
GREEN
BLADES
BLACK
BLADES
B
A
A
B
3 x1.5 V AAA (LR03)
+ A
A
A
/L
R
03
/R
03 1
.5
V –
+ A
A
A
/L
R
03
/R
03 1
.5
V –
– A
A
A
/L
R
03
/R
03 1
.5
V +
3
4
Plug in USB cable
Red light = charging
Green light = fully charged
CHARGING PRECAUTIONS:
• After use, allow drone (battery on bottom) to cool down to room
temperature before charging again.
• Charge drone in an isolated area, away from excessive heat
or moisture.
• If you suspect that the battery is damaged or swelling, turn off the
drone immediately.
• Do not modify, heat, or wet the battery in any way. Only recharge with
provided charger.
1 Disconnect battery wires. Push down the battery
box holder on the rear side of the drone. Pull battery
box out of underside of drone.
1 Unplug battery on drone.
2 Make note of the blade color and letter
(A or B) before removing the blade
from drone. (Markings are located on
the underside of blades and Drone).
3 Remove the small screw using
the mini screwdriver provided.
4 Replace the damaged blade
with a new blade with matching
color and letter. Secure the
blade with the retaining screw.
MAINTENANCE
• Over time, loose hair or carpet fibers may get wound in blades, reducing
performance. Unplug the Drone and remove fibers from motors. (Remove
blades if necessary)
3 Insert LiPo battery into back of drone.
Reconnect the battery wires.
2 Plug charging cord into computer or USB
power block. Once charged, disconnect
battery from USB charging cable.
OPTIONAL BLADE GUARDS
Blade guards are great for beginning pilots and can be
easily installed if desired.
The guards add undesired
weight and reduce flight performance.
Blade guards are optional and should not be used with
advanced flight sensitivity setting 3.
To attach blade
guards, insert the posts of the blade guards into the holes
of the drone. Press in the posts to
lock into place.
• Streaming Video Drone
• Screwdriver
• Screws
• 4 Blade Guards
• USB Charging Cable
• Alternative Pro Thumbsticks
• Rechargeable 3.7v 650mAH LiPo Battery
• Remote Control
• 4 Replacement Blades
• Phone Mount
CONTENTS
REMOTE BATTERIES
REPAIRING DAMAGED BLADES
CHARGING THE DRONE
Loosen the screw in
the Remote Control
battery compartment
door with a Phillips
screwdriver and insert
batteries as shown.
Replace door and
tighten screw.
BATTERIES AND MAINTENANCE
Plug into charging wire
Push down
Disconnect battery wires
Pull battery box out
STREAMING VIDEO DRONE
01601
• Lift joystick upward to
remove.
• Insert thumbstick into
stem to replace.
ALTERNATIVE
PRO THUMBSTICKS
