sky rider sparrow pro, Руководство пользователя

Страница: 7 / 8

13 12
Parts & Repair
REMINDER: Pilots are responsible for any damage caused by improper use.
Parts Replacement
Standard parts such as extra batteries and remotes are available online for purchase when
in stock. However, any non-standard parts such as cameras, screws, bodies, SD cards etc.
can be ordered by placing an inquiry with our parts department at:
partsinfo@dpiinc.com.
Rotor Replacement
The craft comes with replacement rotors if the originals are broken or badly damaged.
Rotors can be removed by hand by pulling up and off of the motor shaft. If the rotor feels
stuck and won’t budge, try using a set of pliers for a firmer grip. Be careful not to damage
the motor shaft or rotor arm assembly.
It is extremely important to use the correct rotor
(A or B) for replacement.
Using the incorrect rotor will make the craft impossible to control.
The marking can be found on the underside of the rotor.
Rotor A
Rotor A
Rotor B
Rotor B
If you are experiencing problems using or flying the craft, consult this table.
Troubleshooting
PROBLEM POSSIBLE CAUSES SOLUTION
Craft does not
respond to controls.
• Lost Wi-Fi connection.
• Low battery
• Poor contact between
power plugs.
• Craft is out of Wi-Fi
transmission range.
• Close app, power OFF
craft and restart.
Perform Wi-Fi
connection again
(see pg. 7).
• Check battery, be sure it
is fully charged.
• Be sure the power plugs
are firmly connected.
• Remain within Wi-Fi
transmission range.
Craft is difficult
to control or flies
erratically.
• Gyroscopes may
be misaligned.
• Place craft on flat
surface and recalibrate
gyroscopes
(see Controls pg. 9).
Craft drifts
while in flight.
• Trim not set or needs
adjustment.
• Adjust trim settings
(see Controls pg. 9).
Craft suffers from
mechanical trouble.
• Damage to body, rotors
or other parts.
• Repair or replace parts
as needed.
LED lights ON but
craft does not
respond to controls.
• Low battery power. • Recharge the battery.