Page 2 of 4
3- Connect the short modular cord [1&2 Phone] on CK-1 to the jack [LINE 1+2] on the
Phone.
4- Connect the audio cord from your audio source, to the AUDIO IN jack on the back of
the CK-1 black box where it says Audio In. NOTE: Use our Audio cable ONLY for CD
players. For DIGITAL PLAYERS use the cable that comes with the player.
5- Make sure that the surface area of the base phone, where the sensor board is to be
mounted, is clean and free of all dust and oil film. Peel off the paper protector from the
bottom of the sensor board, and carefully place it OVER the LINE 1 and LINE 2 buttons
on the RCA phone as shown in Fig #2. Make sure that you align the Sensor Board to the
Edges of the phone as shown in Fig #2.
6- Connect the POWER CUBE from the CK-1 Black Box to 115VAC power. That's it!
LINE 2
LINE 1 + 2
To Wall Jack
To Audio Player
FIG #1
