sks Basic Line 2012, Руководство пользователя, Страница: 20 / 29

~ 20 ~
Mounting instructions (continued)
Before mounting and completing the plastering work
(as shown on the left) it is inevitable to check whether
the housing is flush with the wall. Then complete the
mounting by covering the box with plaster.
The in-wall box is to be flush-mounted into a cutout /
notch in the wall. The table below provides a list of the
dimensions of the in-wall boxes according to their
number of bell buttons.
Bell buttons Dimensions (WxHxD)
1 116 x 177 x 46 mm
2 116 x 202 x 46 mm
3 116 x 227 x 46 mm
4 116 x 252 x 46 mm
5 116 x 277 x 46 mm
6 116 x 302 x 46 mm
7 116 x 327 x 46 mm
8 116 x 352 x 46 mm
Feed the cable through the selected openings into the
box. Make sure there is enough cable to connect the
door station.
The housing is mounted to the wall using 4 screws.
If the in-wall box ends up too deep in the wall, the
retaining ledges may be moved parallel using the two
screws. This allows for an adjustment in depth of up to
a maximum of 9mm. Once the screws are loosened
the retaining ledge may be pulled out until it is flush
with the wall. If this is not the case, the front panel
may not be mounted.