DA 3800 Flange Inlet
Mounting Guide
19
3.4.7 Foaming
SKOV A/S recommends using single-component polyurethane foam or similar.
Check before foaming how much the foam expands.
Wet the faces with water from a mist sprayer before
proceeding with the foaming.
Foam around the inlet, as shown in the drawing. Foam
the entire depth of the wall in the corners of the inlet
and approx. 10 cm to each side.
In the middle part of the inlet, it is essential only to
foam along the edge, as the foam may otherwise
cause the inlet to warp.
Push the foam in against the inlet (5-10 mm) after the
foam has dried a little to allow adequate space for
pointing.
Wet the foam again with water from a mist sprayer.
