7
PLC075TI, PLC125TI, PLC150TI, PLC200TI
SKOPE CONSORT Convection Panel Heaters
Thermal Operated Cut-Out
The appliance is fitted with an Electronic Safety Control (ES). This is
a safety device, which switches the heater off if, for any reason, the
appliance overheats. The ES control can only be re-set after the
appliance has cooled down. In order to re-set the ES control, proceed
as follows:
1.
Switch off appliance and leave for approximately 5 minutes.
2.
Switch appliance back on and ES control will re-set.
3.
Ensure that the appliance is functioning correctly. If the ES
control operates again, the appliance should be checked by a
competent electrician.
The heater carries a 'Do Not Cover' label to warn the user that if the
appliance is covered, there is a risk of overheating.
CAUTION:
In order to avoid a hazard due to inadvertent resetting of the thermal
cutout, this appliance must NOT be supplied through an external timer.
If your heater does not work:
•
Check that power is available to the heater. The neon indicator on
front of the heater should be illuminated.
•
Check that the thermal cut-out has not operated. If the cut-out has
operated follow the re-set instructions above.
•
Do not attempt to repair the heater.
Care
The heater is best wiped down with a damp cloth. Do not use any
abrasive cleaners. Always disconnect the heater from the mains power
before cleaning the heater. When cleaning the heater:
•
Do NOT use any abrasive cleaners
•
Do NOT touch the heater with wet hands, or in any way bring
water into contact with the heater.
