Page 3 of 4
PRN80226 Rev. 1.1 Sep. 2022
Refrigeration
Refrigeration
Freezer
Door Handles
The door handles may be packed inside the cabinet.
Shelves
The wire shelves sit on shelf clips which twist onto the shelf support strips inside the cabinet. The shelves may be positioned at
different heights to suit various product. Use the numbers on the shelf support strips to help set the shelf clips at the same height.
Loading Product
Let the freezer run for 30 minutes before loading it with product for the first time. When loading the shelves with product
:
Door Lock/s
The cabinet may be fitted with bracket locks or key locks, located above or below each door. Bracket locks require a lock (padlock
or similar) through the brackets to lock the door. Key locks can be locked with the supplied key.
To fit a door handle
To remove a door handle
1. A metal spring is fitted inside the
handle mounts. Ensure the
springs point up.
1. Peel back the door gasket from
behind the handle mounts on the
inside of the door frame.
2. Unscrew the handle mounts
through the holes on the inside of
the door frame, and remove the
handle.
3. Only unscrew the top and bottom
screws. Do
NOT
unscrew the
middle screw.
2. Place
BOTH
handle mounts
simultaneously onto both door
brackets. Then push the handle
down onto the brackets until the
handle locks in place.
4. Remove the bracket/s from the
handle mount by pressing the
bracket in and down until it
unclips from the handle mount.
Troubleshooting
•
If the handle doesn’t lock into
place, check that the spring clips
are pointing up and try again.
•
If only one end of the handle locks
into place, remove the door
handle and refit with both handle
mounts located onto the brackets.
5. Fit and screw the bracket/s back
onto the door. Ensure the catches
are pointing up as pictured.
6. Clip the gasket back into place on
the inside of the door frame. If the
gasket is out of shape, use a hair
drier to heat and reshape it.
To fit a shelf clip
Twist anticlockwise
onto the shelf support
strip.
To remove a shelf clip
Pull the centre tab up
and twist off clockwise.
To adjust the shelf clip height
Pull the centre tab up, and
slide up or down as required.
Once in position, ensure it
clicks into place.
Handle
Bracket
Front of
door
Bracket
Spring clip
(pointing up)
Bracket
Handle mount
Handle
Bracket
Catch
Catch
Shelf Loading
Do not overload the
shelves.
Shelf Flexing
Remove product if the
shelf is flexing.
Shelf Overhang
Do not let product
overhang the shelves.
Front
Top
Back
MAX
46kg
per shelf
Internal Airflow
Leave 25 mm space
between product and
the back of cabinet
interior.
Cabinet Floor
Do not load product on
the cabinet floor. Use
the shelves.
Load Limit
Do not load product
above the load limit
indicators on the cabinet
interior sides.
LOAD LIMIT
