Skoda Octavia III 2013, Руководство по обслуживанию

Страница: 66 / 172

– Perform a test drive and again check the coolant antifreeze
protection.
3.9.2 Inspecting coolant level (volume)
The coolant expansion reservoir is located on the right of the en‐
gine compartment.
– Check coolant level when the engine is cold.
♦ Pre-sales inspection and handover inspection: above the
-Min- marking.
♦ Inspection: above the -Min- marking.
– When the coolant level is low, top up the missing amount of
coolant according to the mixing ratio ⇒ page 58 .
WARNING
♦ Coolant additives are toxic!
♦ Do not inhale coolant vapours, do not swallow coolant,
avoid contact with skin and eyes; hazardous if consumed!
♦ In the event of a loss of coolant, which was not caused by
the current consumption, determine the cause of the leak‐
age and eliminate it (repair measure) ⇒ Engine; Rep. gr.
19 .
– If required, top up with coolant.
3.10 Poly V-belt: Check condition
Special tools and workshop equipment required
♦ Wrench socket
Perform the following procedure:
– Raise vehicle.
– Remove the noise insulation.
– Remove cap for screw of v-ribbed belt pulley - if present.
– Use a socket wrench to crank the engine at vibration damper/
belt pulley -2-.
– Inspect V-ribbed belt from below for:
Octavia III 2013 ➤ , Octavia III 2014 ➤
Maintenance - Edition 12.2014
62
ProCarManuals.com