Skoda KAROQ 2017, Руководство пользователя

Страница: 192 / 324

›
By turning off the ignition for longer than 120 minutes.
Abort route guidance
If the ignition is switched off and on again, then the route guidance is contin-
ued depending on the stop time in one of the following ways.
▶ Within 15 min. - route guidance continues to take the calculated route into
account.
▶ From 15 min to 120 min - after confirming the message on the infotainment
screen, the route guidance continues, taking into account the calculated
route.
▶ After 120 min - the route guidance is cancelled.
Route
Route details
Fig. 227 Route details: a route destination/several route destinations
During route guidance, the Route details (Information about the current route)
can be displayed.
›
In the Navigation main menu, tap the function surface

→ Route details.
A route destination
In the route plan, the following information is displayed at the destina-
tion » Fig. 227 -

.
Area with function surfaces
Destination information
Estimated time of arrival at destination / remaining driving time to desti-
nation
A
B
  
Remaining distance to the destination
Chosen route type (economic, fastest, shortest)
Current vehicle position (address / GPS coordinates)
The display of the arrival time or the remaining driving time can be adjusted as
follows.
▶
In the Navigation main menu, tap the function surface

→ Advanced settings →
Time display:) .
Several route destinations
In the route plan, the following information is displayed at the respective desti-
nations » Fig. 227 -

.
Area with function surfaces
Stopover (with sequential number)
Final destination
Estimated time of arrival at destination / stopover
Driving distance to destination / stopover
Change destinations with each other
Delete the destination
Continuation of the route guidance from the selected target (previous
waypoints are skipped)
Display the destination details
» page 187
Insert destination into the route
▶ In the area A , tap on the function surface Enter destination and enter a new
destination.
▶
or: In the area
A
, tap on function surface Destinations and select a destination
from the list of stored destinations.
Each additional destination is added to the list as the first subsequent destina-
tion route.
Change positions of destinations with each other
▶ The relevant function surface

and move the destination to the desired po-
sition.
With destinations on the route already reached the note Destination reached is
displayed below the destination name. It is not possible to change the position
of these destinations with each other.


C
D
A








190
Infotainment