VISIT SKLZ.COM TO LEARN MORE
1. Carefully remove goal from storage bag (A), and unroll net from base frame (B).
Net is permanently attached to the frame for easy setup.
3. Roll frame so it lays with rubber feet facing down. Unlock and unfold front
arms away from you until they lock into place. Release and extend left and right
telescoping sections at back to bring base frame to full width.
5. Attach net to tops of support poles by inserting the pins at the top of the pole
into the clips attached to the net. Connect the front of the net to the taller
section of the Dual Tension-Tite™ support poles first, then the back second.
Follow the same order on the opposite side. You may need to lean the goal
forward in order to reach top corners. Be careful not to let go until the pin is
fully inserted to avoid injury. Connect the bottom of the posts to the frame by
hooking the bottom loop to the front of the post. Use ground stakes (D) to
secure the assembled goal in place for use.
2. Unfold two side legs of the base frame by swinging them left and right from
center hinge until they lock into place.
4. Assemble the Dual Tension-Tite™ support poles (C) and insert into each of the
rear corner joints of the base frame and lock into place. Poles will fit in either
side. The segments of these support poles are permanently connected using
elastic cords to simplify assembly.
6. Disassemble your goal by reversing the above procedure. Begin by
detaching the net from the support poles by pulling the pins from the corners.
Disassemble the support poles, and fold connected segments together. Use
the silver release buttons to fold front arms back and to slide telescoping
sections together. Fold base frame at center hinge and roll net around frame.
Carefully place into storage bag.
GETTING STARTED
IN THE BOX
STORAGE BAG
A
BASE FRAME WITH
ATTACHED NET
B
B
DUAL TENSION-TITE
™
SUPPORT POLES (2)
B
C
GROUND STAKES (4)
D