SKLZ.com
PRO MINI HOOP SYSTEM
Secure the Middle and Top Poles the same way.
NOTE: Before play, make sure you have tightened all nuts and bolts.
STEP 10
– FILL BASE FOR PLAY
Move the Pro Mini Hoop System to desired location. Remove the Red Base Cap and fill
the Base up the rest of the way with water or with an additional 80 pounds of sand.
Your Pro Mini Hoop System is now ready for use.
ADJUSTING THE HEIGHT
Unclip the safety chain on the Height Adjustment Handle. Grip the handle firmly and pull
out the Locking Pin. Raise or lower the handle to the desired backboard height. Once
at desired height, line up the holes and slide the Locking Pin through and clip the safety
chain to the pin.
To shorten the Pro Mini Hoop System for smaller children or poolside use, remove the
black bolt connecting the Top Pole to the Middle Pole and pull out the locking pin.
Set aside. Pull the Top Pole with Backboard off and set aside. Remove the black bolt
connecting the Middle Pole and Bottom Pole as well as the locking pin. Pull off the
Middle Pole. Screw in the bolt and attach the locking pin to the Middle pole for safe
keeping. Slide the Top Pole with Backboard onto the Bottom Pole and attach with the
locking pin and bolt.
Additional Mini Basketballs and replacement nets can be purchased at SKLZ.com or by
calling toll free: 1-877-225-7275 x128.
STEP 7
– HEIGHT ADJUSTMENT POLE AND HANDLE ASSEMBLY
Slide the Height Adjustment Handle (8) onto the Height Adjustment Pole
(7) by aligning the two holes of the Height Adjustment Pole with the two
bottom holes on the Height Adjustment Handle. Slide the Locking Pin
connected to the handle through the two poles to connect them. Clip the
safety chain to the pin to secure.
NOTE: Moving the Height Adjustment Handle up and down these holes
will raise and lower the backboard. This configuration has the
backboard at its lowest height.
STEP 8
– HEIGHT ADJUSTMENT HANDLE AND BACKBOARD/POLE ASSEMBLY
Attach the Height Adjustment Handle to the Bottom
Backboard Brackets with the remaining 3.25” hex bolt, tighten
with 2-Sided Wrenches (Connection A - see image). Make sure
that the handle is pointing away from the Backboard.
Next, tighten the nut and bolt connection of the Lower
Backboard Brackets and Top Pole from STEP 5
(Connection B - see image).
Attach the Height Adjustment Pole to the bottom of the Top
Pole with the 1.75” hex bolt and nut (Connection C - see
image). Tighten to secure.
NOTE: Before you continue, unclip the safety chain, firmly hold
the handle and slide out the locking pin. The handle
should slide up and down the pole freely, raising and
lowering the backboard. If it does not move, check the
three circled nut and bolt connections to see if they
have been overtightened. Relock the adjustment handle with the locking pin.
STEP 9
– POLE AND BASE ASSEMBLY
Slide the Middle Pole (3) onto the Bottom Pole (2). Make sure the connector is pointing
towards the back of the base. Slide the Top Pole (4) with Backboard assembly onto the
Middle Pole (3).
NOTE: For pool height or smaller children, omit the Middle Pole and
connect the Top Pole directly onto the Bottom Pole.
Slide one of the locking pins through the Bottom and Middle Poles.
Clip the safety chain to the pin to secure. Slide a locking washer onto a
1.5” bolt with blue adhesive and screw it down the back of the Middle
Pole to the Bottom Pole to secure. Tighten with a 2-Sided Wrench.
Check these circled connections.
A.
B.
C.