1
1
2
3
2
3
USAGE
2
3
2
3
1
1
SWING PLANE SETUP
HIP STABILITY / ANTI-SWAY SETUP
HEAD STABILITY SETUP
KNEE STABILITY SETUP
1
- Press the silver button to release
the Base Pole and set it to one of the
lower positions toward the ground.
2
- Rotate the Secondary Pole to a horizontal
position and add the second set of foam
pads to protect the Trainer from your
club’s impact.
3
- You may wish to extend the Base Pole
to raise the Secondary Pole further off
the ground, depending on skill level and
difficulty or club usage. When using a driver,
make sure the Secondary Pole is higher on
base pole. Lower the height of Secondary
Pole closer to the ground for irons
and wedges
This configuration of your All in One Swing
Trainer will help improve the golfers swing
plane by promoting an in to in swing plane.
This will eliminate slices and encourage a
golfer to turn their hands over for
straighter shots.
1
- Press the silver button on the Base to adjust
Base Pole to the 1st or 2nd hole
2
- Set the Secondary Pole to vertical and
extend the Base Poll.
3
- Adjust so the end of the Secondary Pole
rests to the right of the hip (for right handed
golfers) to prevent swaying of the hips. Use
the extension feature if needed to gain a
greater amount of length and fine adjust by
loosening the T-Connector and sliding the
pole to fit any golfer.
1
- Press the silver button on the Base to
adjust Base Pole and raise it to the golfer’s
head level.
2
- Fully extend the Secondary Pole so it reaches
to the height of the golfer. Use the extension
feature as well as releasing the T-Connector
and sliding the pole out. You may even
wish to remove the Foam Pad from one end
to allow more extension. Your All-In-One
Swing Trainer will reach a maximum height of
over 7 feet.
3
- If you wish to prevent the head from moving
left to right in the swing, rest the end of the
foam pad to the side of the head. If you wish
to prevent the head from moving forward
and back in the swing, rest the end of the
foam pad in front of the forehead.
1
- Press the silver button on the Base Pole to
adjust Base Pole to the 1st or 2nd hole
2
- Rotate Secondary Pole so it stands upright,
parallel to the Base Pole.
3
- Adjust so the end of the Foam Pad hits the
outside of the right or left knee to prevent
swaying of the knee.
To prevent over bending of knee or
straightening of the knee during the swing
adjust, angle and Secondary Pole so it rests
behind the knee.
PUSH BUTTON TO
RELEASE POLE
PUSH BUTTON TO
RELEASE POLE
PUSH BUTTON TO
EXTEND POLE
PUSH BUTTON TO
RELEASE POLE
PUSH BUTTONS
TO EXTEND POLE
PUSH BUTTON TO
RELEASE POLE
2081 Faraday Ave Carlsbad, CA 92008 U.S.A | 877.225.7275 | SKLZ.com
Made in China
V3
SKLZ offers a limited 1-Year warranty for this product, visit SKLZ.com for
full warranty details and to register your product.
Made in China. ©2014 Pro Performance Sports, LLC. All rights reserved. Manufactured and distributed by SKLZ/Pro Performance Sports.
SKLZ and SKLZ Pro Grade are registered trademarks of Pro Performance Sports, LLC., its subsidiaries and affiliates. Unauthorized
duplication is a violation of applicable local and international laws.
VISIT SKLZ.
COM
FOR
INSTRUCTIONAL VIDEO AND CONTENT