2021-06-24
Page 33 of 40
CU-M001 User manual
System alerts
When the alert symbol is present pressing it will show a table of alerts. These can be acknowledged.
Current causes for system alerts are:
- No communication with electronic unit
The screen will show: “No communication” (the all data will be -.- and the time will not be present,
but the ‘:’ will be flashing). The time will dissapear, but the : will continue to flash
-No communication with the sensor (the speed, Depth and temp data will be -.- but other functions
will work.
- Bad data from sensor (Check the diagnostics menu)
- Other internal error detected (Check the diagnostic menu)
Speed alerts
Alerts can be set for high speed and low speed, If in use, they should be made accessible as
informations on the right hand side. In this case they can be changed by pressing the information
for 2 seconds. Alerts can also be set and adjusted in the Alert menu page
Access to “Alert setup” pages
The user enters from “Config” page. Press “Down” button
q
until “Alert setup”
