Skipala DIGR-1502/E, Руководство пользователя

Страница: 13 / 24

13/23
the output storage tank of the feeder. We recommend
setting parameters to 0 s.
If the controller is in the W-wait status parts are
taken from the storage and their movement causes
a short interruption of the signal from the filling
sensor. The Delay ON (parameter A12) must be longer
than the interruption of the signal. Then the
interruption will be ignored and the controller
switches into the R-run status after the storage tank
is discharged. The same occurs after the storage tank
is filled. Individual parts pass around the sensor and
create short impulses. The Delay OFF (parameter A13)
must be longer than these impulses. Then they will be
ignored and the controller switches into the W-wait
status after the actual filling of the magazine. The
parameters can be set from 0-25 s.
8.4. A14 Ramp up/down
This parameter can be used when starting and running
down the feeder to change the value of the amplitude so
that the feeder starts to run fluently. The setting
range is 0-6 s. The time relates to starting from 0% to
100% and running down from 100% to 0%.
8.5. A15 Batch ON
A16 Batch pause
In some cases, the feeder needs to work with
interruptions, in batches. Use parameter A15 to set the
time during which the batch is supplied, parameter A16
the time of the pause between batches.

Tip for you : The vibrating feeder serves as
a pre-storage tank that delivers the parts to the
circular feeder on the basis of the full sensor signal.
If you take advantage of the batch function, the
pre-storage tank fulls only one batch, waits, then
evaluates the status of the full sensor and, if
necessary, gives a next batch. Parts of the hopper will
spread evenly during the pause. This ensures that the
hopper does not overfull.
8.6. A17 Amplitude Maximum limit
A18 Amplitude Minimum limit
Use these parameters to restrict the amplitude
setting in parameter A11.