Skil PWRCORE DL6293B-00, Руководство пользователя

Страница: 12 / 68

12
Direction-of-Rotation (Forward/Center-Lock/Reverse) Selector (Fig . 3)
WARNING
After tool use, lock the direction-of-rotation selector in the “OFF”
position (center-lock) to help prevent accidental starts and possible injury .
Your tool is equipped with a direction-of-rotation selector, located above the trigger switch. This
selector is designed for changing the direction of rotation of the bit and for locking the trigger in
the “OFF” (center-lock) position.
a. Position the direction-of-rotation selector to the far left of the tool to drill holes or drive the
screws in.
b. Position the direction-of-rotation selector to the far right of the tool to remove screws.
c. Position the switch in the “OFF” (center-lock) position to help reduce the possibility of
accidental starting when the tool is not in use.
NOTICE: To prevent gear damage, always allow the drill driver to come to a complete stop
before changing the direction of rotation.
NOTE: The drill driver will not run unless the direction-of-rotation selector is engaged fully to
the left or the right.
Fig . 3
Forward Center-Lock Reverse
Variable-Speed Trigger Switch
(Fig. 4)
Your tool is equipped with a variable-speed
trigger switch. The tool can be turned “ON” or
“OFF” by depressing or releasing the variable-
speed trigger switch.
The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure.
Fig . 4
Variable-
Speed Trigger
Switch