Skil PWRCORE 20 PL5938E-00, Руководство пользователя, Страница: 10 / 12

10
• Battery protection
Switches off the tool or prevents the tool from being
switched on, when
- the load is too high
-
the battery temperature is not within the allowable
operating temperature range of -20 to +50°C
- the lithium-ion battery is nearly empty (to protect
against deep discharge)
! do not continue to press the on/off switch after the
tool is switched off automatically; battery may be
damaged
APPLICATION ADVICE
• When planing one may use a dust bag
• For chamfering edges use the V-groove in the front shoe
e
- set knob to position “0” for chamfering edges similar to
selected groove
- for larger grooves turn knob to select the required
planing depth
! always test out first on a piece of scrap material
• When planing rabbets you will achieve better results by
using a parallel guide to adjust rabbeting width
r
MAINTENANCE
• This tool is not intended for professional use
• Always keep tool and cord clean (especially ventilation
slots
1
)
! remove battery from tool before cleaning
ENVIRONMENT
• Do not dispose of electric tools, batteries,
accessories and packaging together with household
waste material. The electric tools, accessories and
packaging should be sorted for environmental-
friendly recycling
! prior to disposal protect battery terminals with
heavy tape to prevent short-circuit
-
put knife back in cutter block in reversed position, or
use new knife
6
d
! groove in knife should match ledge in cutter block
! place knives against support plate
6
e
- firmly tighten 3 bolts with wrench
6
f
! change/reverse knives in time; only use sharp
knives
! always change/reverse both knives at the same
time
! do not attempt to adjust the knives with cutter
block screws, which are pre-set at manufacturing
• Adjusting planing depth
7
- turn knob in “+”/”-” direction for increasing/decreasing
planing depth
- use scale as reference
- always select a shallow planing depth and repeat the
planing and adjusting process until the required depth
is reached
• Dust/Chip-Extraction Port
8
- select desired Dust/Chip-Extraction Port side (left or
right) with switch
- connect vacuum cleaner with adaptor to Dust/Chip-
Extraction Port as illustrated
- one may also connect dust bag to the selected Dust/
Chip-Extraction Port as illustrated
! do not attempt to remove any obstructions from
the Dust/Chip-Extraction Port while knives are
rotating
• Park rest
9
- protects workpiece from damage when tool is put aside
- will automatically fold backwards when planing
• Operating the tool
- adjust planing depth
- place tool on workpiece
! ensure that only the front shoe rests on the
workpiece and that the knives do not touch it
- switch on the tool by first pressing lock-off button
1
(=
safety switch which cannot be locked) and then pulling
trigger
1
! before the knives reach the workpiece, the tool
should run at full speed
- hold the tool firmly with both hands and guide it forward
in a continuous stroke
- use the tool with its base-plate on the workpiece
-
do not tilt the tool in order to avoid unwanted planing
marks
! before switching off the tool, you should lift it from
the workpiece
- switch off the tool by releasing trigger
• Planing rabbets
q
-
select required planing depth
- select rabbeting depth by using rabbeting depth
adjuster
- place tool on workpiece
- start planing
-
maximum rabbeting width 82 mm
- maximum rabbeting depth 8 mm
! while working, always hold the tool at the grey-
coloured grip area(s)
w
- keep ventilation slots
1
uncovered
-
do not apply too much pressure on the tool; let the tool
do the work for you