Ski-Doo FORMULA III, Руководство по ремонту

Страница: 102 / 356

Section 04 ENGINE
Sub-Section 03 (599 AND 779 ENGINE TYPES)
04-03-2
REMOVAL FROM VEHICLE
Remove or unplug the following then lift off en-
gine from engine compartment.
NOTE : 3-cylinder engine is more heavy
then a 2 cylinder engine. It weights about 45
kg (100 Ib). Use of a hoist is recommended.
– belt guard
– drive belt
– drive pulley
– air intake silencers
– carburetors
– exhaust pipes
– after muffler
– wiring connections
– coolant
– rewind starter
– CDI box from accessory support
– oil injection inlet line at oil injection pump
– coolant hoses
– engine support screws
– engine stopper (left rear of engine)
– impulse lines from engine
1,2,3,4, Engine Support Nut and
Manifold Screw
Torque the engine / support nuts to 35 N•m (26
lbf•ft).
Torque rubber mount / support bracket to 29 N•m
(21 lbf•ft).
Torque rubber mount / support nuts to 37 N•m
(27 lbf•ft).
Torque manifold screws to 10 N•m (89 lbf• in ).
INSTALLATION ON VEHICLE
To install engine on vehicle, reverse removal pro-
cedure. However, pay attention, to all appropriate
component / system reinstallation procedures de-
scribed throughout this
Shop Manual and to the
following :
– After throttle cable installation, check carbure-
tor maximum throttle opening and oil injection
pump adjustment.
– Check pulley alignment and drive belt tension.
— Should as light exhaust leak be experienced at muf-
fler ball joint, Dow Corning sealer no. 736 RTV (P / N
413 7092 00) can be used.