Ski-Doo Expedition Series, Руководство оператора

Страница: 103 / 179

MAINTENANCE PROCEDURES
Recommended Engine Coolant
Always use ethylene-glycol antifreeze
containing corrosion inhibitors specifi-
cally for internal combustion aluminum
engines.
Cooling system must be filled with
LONG LIFE ANTIFREEZE (P/N 219
702 685) or with distilled water and an-
tifreeze solution (50% distilled water,
50% antifreeze).
Injection Oil (600 HO E-TEC
and 800R E-TEC)
Adding Injection Oil
Remove the upper RH side panel. Re-
fer to
SIDE PANELS
in
CONTROLS,
INSTRUMENTS AND EQUIPMENT
subsection.
Always maintain a sufficient amount of
recommended injection oil in the injec-
tion oil reservoir.
mmo2009-004-028_a
TYPICAL
1. Oil reservoir
Unscrew injection oil reservoir cap to
fill up reservoir then fully tighten.
NOTE: Do not overfill. Do not pass
the MAX range in the reservoir filler
neck.
NOTICE
Check level and refill ev-
ery time you refuel.
WARNING
Do not overfill. Reinstall cap and
fully tighten.
Wipe off any oil
spills. Oil is highly flammable
when heated.
Engine Oil
(1200 4-TEC / 900 ACE)
Engine Oil Level Verification
NOTICE
Check level before each
ride and refill if necessary. Do
not overfill. Operating the engine
with an improper level may se-
verely damage engine. Wipe off any
spillage.
Place vehicle on a level surface and
proceed as follows to check oil level:
1. Start engine and let it reach its nor-
mal operating temperature. Engine
is at normal temperature when rear
radiator gets warm, indicating that
the thermostat is open.
2. Let engine run at idle for 30 more
seconds.
3. Stop engine.
4. Open the LH side panel, refer to
CONTROLS, INSTRUMENTS AND
EQUIPMENT
.
5. Remove the drive belt guard, refer
to
DRIVE BELT GUARD
.
6. Remove dipstick from the filler tube,
then wipe it clean.
7. Completely insert dipstick in the
filler tube.
8. Remove dipstick and check the oil
level. Oil level should be between
the MIN and MAX marks as shown,
add if necessary.
______________
101