SKF TKRT 20, Инструкция по эксплуатации

Страница: 12 / 100

10 SKF TKRT 20
3.7 Operation of Maximum & Minimum modes
Speed Capture functions - mx, mn.
See section 3.1
• Having selected the required mode, i.e. Maximum or Minimum, (mx,mn).
• You are now ready to Capture a reading “On Demand” but continuing to
operate normally.
• When a capture test is ready to commence, while the Measure button is
held On, press Programme button once, at this point the instrument will
switch into high speed Timebase mode,
(0,1 Seconds) and will Capture the highest or lowest reading after
pressing the Programme button.
Releasing the On button will hold the reading and cancel the Capture
mode until another Capture measurement is required, when 3.7 should
be repeated.
3.8 Count measurement mode - cnt
See section 3.1
• Select the count mode (cnt).
• For counting revolution optically, point the light beam at the target and
the instrument will measure all revolutions (revs) until button is released,
the display will hold Count for 1 minute.
• By contact method, it contact adaptor, press speed cone onto the end of
the shaft, the Instrument will count revolutionds.
3.9 Total Linear Length measurements - mt, ft, yd
See section 3.1
• Select any linear unit of measurement, press contact wheel onto moving
surface and commence Count by pressing & holding Measure button On,
Count will increment until button is released.
• The displayed value can be scanned through the equivalent values of
Metres, Feet, Yards, Count by pressing the Programming button, the
instrument automatically calculates the appropriate reading.
Note:
Measurement Units will be stored in originally programmed
parameter e.g. metres.