SKF PowerLuber 1882E, Инструкция по эксплуатации и обслуживанию, Страница: 15 / 24

Filling gun from bulk
container
1 Remove pump assembly from grease
tube assembly
2 Pack lubricant into cavity of pump
assembly
3 Insert open end of grease tube assembly
into lubricant Slowly pull follower handle
back while pushing grease tube assembly
deeper into lubricant to prevent air
pockets from being pulled into
grease tube
4 With follower rod fully extended, pull it
sideways to latch rod groove into slot in
grease tube assembly cap
5 Loosely assemble pump to te grease tube
assembly Release follower rod from
grease tube assembly cap and disengage
follower rod from follower by rotating
follower handle
6 Push follower rod into grease tube
assembly
7 Unscrew grease tube assembly from
pump until lubricant oozes from
interface Tighten grease tube assembly
into pump assembly
8 Reset display reading after purging air
9 Refer to section titled
LCD display and LED light ,( † page 13 )
Filling gun with filler pump
1 Engage follower rod with follower by
rotating follower handle
2 Insert gun bulk fill valve into filler
pump socket
3 Operate filler pump to fill container- Do
not overfill! When follower rod groove is
exposed, grease tube assembly is filled
Follower rod will be extended
approximately 8 in
(20 cm)
4 Disengage follower rod from follower by
rotating follower handle
5 Push follower rod into grease
tube assembly
6 Reset display reading after purging air
Expelling air pockets
(air purging)
1 Withdraw follower rod from grease tube
assembly cap and engage it with follower
by rotating follower handle
2 Unscrew plug of vent valve 3 to 4 turns
Exert force on follower handle until
grease flows through small hole in side of
vent valve
3 Tighten vent valve
4 Pull trigger in short bursts to operate gun
until trapped air is expelled Disengage
follower rod from follower by rotating
follower handle Push follower rod into
grease tube assembly
5 If step 2 fails, unscrew grease tube
assembly 3 turns from pump assembly
6 Exert force on follower handle until
lubricant oozes from grease tube
assembly and pump assembly interface
7 Retighten grease tube into pump
assembly Disengage follower rod from
follower by rotating follower handle
Push follower rod into grease
tube assembly
NOTE
Remove air pocket! Air pocket at grease
inlet will prevent grease from
being pumped Unscrew the vent valve
three to four turns to remove small air
pockets trapped in this area If the air
pocket is substantial and no grease
flows from coupler after trigger is pulled
for 15 seconds, refer to the following
steps
15