SKF PowerLuber 1882E, Инструкция по эксплуатации и обслуживанию

Страница: 16 / 24

Charger operation
Charging battery
pack
Before using PowerLuber first time, battery
pack should be fully charged If battery pack is
installed in PowerLuber, remove and follow
charging procedure
Lincoln chargers are designed to charge
Lincoln lithium-ion batteries in 30 to
90 minutes depending on battery state opf
charge and temperature
Charging procedure
Make sure power circuit voltage is as shown
on charger specification plate
1 Plug charger into appropriate outlet
before inserting battery pack
2 Insert battery pack into charger
Green (charging) light will blink
continuously indicating that charging
process has started
3 Completion of charge will be indicated by
green light remaining on continuously
Pack is fully charged and may be used at
this time
4 Disconnect charger from power source
when not in use
NOTE
Battery temperature will increase
during and shortly after use Batteries
may not accept a full charge if they are
charged immediately after use Allow
the battery pack to cool to room
temperature before charging for best
results
NOTE
Do not charge battery when
temperature is below 40 °F
(5 °C) or
above 104 °F (40 °C)
Vent slots in top and bottom of
charger must not be obstructed

C AUTION
Do not probe with conductive objects
120/230 V AC present at charging
terminals
Failure to comply may result in death
or personal injury
Fig. 4
Indicator light operation
Pack charging..................
Fully charged...................
Replace pack...................
Problem power line........
Hot/cold pack delay.........
16