Operating instructions
1
Fully extend and lock cord in place before
using.
2
To lock, pull cord to desired length.
Slowly
let the cord retract back into the reel
some, until you hear a clicking sound.
Stop the cord from retracting when you
hear the clicking sound. Cord should now
be locked in place. If not, repeat previous
instructions.
3
To retract cord, pull cord out a few inches
until you feel the reel pulling the cord
from your hand.
Do not let go of the
cord while it is retracting
. Hold onto
cord until it is completely wound into the
reel. Failure to do so may result in per-
sonal injury and/or damage to the reel
itself.
4
To lock multi-angle bracket into place, pull
looped spring loaded pin out, set reel to
desired angle and release looped spring
pin to engage into one of the holes to lock
it.
•
•
Do not overload circuit
- Check the
amperage rating of the tool or appli-
ance that you are using before con-
necting anything to the outlet(s) on
this product to be sure that you are
not overloading the circuit. The am-
perage rating of this reel can be found
on the label on the reel itself. If the
circuit breaker blows, unplug all de-
vices and re-set the circuit breaker.
Double check the amperage rating of
your device before plugging it back in.
•
Do not service this reel light while it
is plugged in.
It may cause electrical
shock
•
Opening reel may cause injury.
Unit
has a tightly wound clock spring for
retraction.
C a u t i o n
3
