pressure to increase, which may open the relief valve and allow gas to
escape.
•
If the product is not in use, the gas must be turned off at the supply cylinder
and disconnected.
•
Do NOT store a spare LP gas cylinder under or near this appliance.
•
Never fill the cylinder beyond 80 percent full.
•
A fire causing serious injury or damage to property may occur if the above is
not followed exactly.
•
Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only
install the type of dust cap on the cylinder valve outlet that is provided with
the cylinder valve. Other types of caps or plugs may result in leakage of
propane.
•
Never attempt to attach this product to the self-contained LP gas system of a
camper trailer, motor home or house.
•
Never use gasoline, kerosene or alcohol with this product.
•
Your product has been checked at all factory connections for leaks. Recheck
all connections as described in the
“Operating Instructions” section, as
shipping can loosen connections.
•
Product performance can vary due to weather, wind and other environmental
conditions.
•
Unit will operate at reduced efficiency below 10°C (50°F).
•
Check for leaks even if your unit was assembled for you by someone else.
•
Do NOT operate if a gas leak is present. Gas leaks may cause a fire or
explosion.
•
You must follow all instructions in the “Checking for Leaks” section before
operating. To prevent fire or explosion hazard when testing for a leak:
a. Always perform a leak test before lighting the product and each time the
cylinder is connected for use.
b. No smoking. Do NOT use or permit sources of ignition in the area while
conducting a leak test.
c. Conduct the leak test outdoors in a well-ventilated area.
d. Do NOT use matches, lighters, or a flame to check for leaks.
e. The use of alcohol, prescription or non-prescription drugs may impair the
consumer’s ability to properly assemble or safely operate the appliance.
f. Strong odors, colds, sinus congestion, etc. may prevent the detection of
propane. Use caution and common sense when testing for leaks.
g. Do NOT use the product until any and all leaks are corrected. If you are unable
to stop a leak, disconnect the LP gas supply. Call a gas appliance
serviceman or your local LP gas supplier.
•
This product is designed to operate at an inlet pressure of 10 psi high pressure.
•
Do NOT store or use gasoline or other flammable liquids or vapors within 7.62
m (25 feet) of this appliance.
•
Do NOT use in an explosive atmosphere. Keep product area clear and free
from combustible materials
(such as building materials, paper or
cardboard, feathers, straw and dust), gasoline and other flammable vapors
and liquids
(such as solvents, paint thinner, dust particles or unknown