SKC AirChek 52, Руководство по эксплуатации

Страница: 2 / 13

Form 37714 Rev 1809
Page 2 of 13
www.skcinc.com
Charging train with
single PowerFlex charger
Charging
jack
Power
cable
Charger
Charging
cable
Getting Started
Charge the Battery Pack
For optimum charge, ensure that the pump is not running.
1. Activate the charger (follow PowerFlex Operating Instructions 40069) .
2. Insert the charging cable connector into the charging port on the charger.
See right .
3. Insert the charging plug end of the cable into the jack on the back of the
pump’s ba tt ery pack (Figure 1) .
4. Charge the ba tt ery completely (the LED at the port connected to the pump
is a steady green) before using the pump.
5. Disconnect the charging cable from the back of the pump’s ba tt ery pack.
Notes and Cautions
• To comply with intrinsic safety regulations, do not charge or operate the pump from the charger in hazardous locations.
• Using a non-approved charger voids any warranty.
• Using a repaired or rebuilt battery pack voids any warranty and the UL Listing for intrinsic safety.
• Using any device other than the approved battery pack to power the pump voids the UL Listing for intrinsic safety and any warranty.
• Ensure proper orientation of charging cable before plugging it into the charging jack. Improper orientation/contact will short-circuit
the battery and voids any warranty.
• Short-circuiting the battery pack will render it immediately inoperative.
• Failure to follow warnings and cautions voids any warranty.
• The battery pack may be kept on the SKC-approved charger for an inde fi nite time.
For more information on SKC pump battery packs, visit www.skcinc.com/catalog/pdf/instructions/1756.pdf.
Use the Pump with AC Power (Power option in non-hazardous locations)
Do not use the pump with the Battery Eliminator in hazardous locations. UL Listing for intrinsic safety is not in effect during pump
operation with the Battery Eliminator.
The Ba tt ery Eliminator is an accessory that converts alternating current (AC) to direct current (DC) from which the pump can be operated
for extended runs. The Ba tt ery Eliminator should be used in non-hazardous locations only. See Accessories.
1. Remove the ba tt ery pack from the pump. See Replace the Ba tt ery Pack .
2. The Ba tt ery Eliminator is comprised of two pieces, a wall cube and a power adapter. Plug the wall cube into a standard wall outlet
and insert its plug end into the power adapter.
3. Fit the power adapter on the pump in place of the ba tt ery pack.