Skanti DSC 9001, Техническое руководство

Страница: 87 / 178

DESCRIPTION
General
Correct installation of the DSC 9000 is important for maximum performance and reliability. This
chapter provides specific information about the installation of each unit, their interconnection and
connection to other equipment.
Mounting the Units
DCU 9000 Control Unit
The DCU 9000 control unit is adaptable to a variety of mounting methods and should be placed
with convenient operation in mind. It may be mounted directly on the front of the DU 9000 forming
an integrated controller-receiver unit, or it may be installed separately with or without the mounting
bracket.
DCU 9000 mounting on DU 9000
When mounted on the front of the DU 9000 (fig.1 at page 3-12), the two units must be interconnected
by means of the ribbon cable included. Depending on wich way the DCU 9000 is turned relative to
the DU 9000, the cable must be bent as shown in fig.3a at page 3-14 or fig.3b at page 3-14
respectively. To install the ribbon cable, remove the top cover of the DU 9000. Plug the cable into
the corresponding socket on PCP 717 and place it between the two guiding tabs at the front top of
the DU 9000. Refit the top cover. Plug the D-sub connector into the Net socket on the DCU 9000
as shown in fig.4 at page 3-15 and arrange the ribbon cable appropriately before fixing the DCU
9000 to the DU 9000.
All external connections to the DSC 9000 are made to the connectors at the rear of the DU 9000.
DCU 9000 with Mounting Bracket
The mounting bracket (fig. 5 at page 3-16) is used for table mounting of the DCU 9000, and may
also be used for bulkhead and console mounting as shown in fig.6 at page 3-17 and fig.7 at page
3-18. Fig.7 shows how the mounting bracket may be installed behind a bulkhead or a console panel
for low profile mounting. Fig.8a and 8b at page 3-19 and fig.9a and 9b at page 3-20 shows how
flush mounting may be obtained and gives the dimensions for the necessary hardware.
External connections to the DCU 9000 are made to the terminal strips of the mounting bracket. For
top side cable entry the Terminal Board may be dismantled and turned 180 degrees as illustrated
in fig.10b at page 3-21.
DESCRIPTION INSTALLATION
DSC 9000 TECHNICAL MANUAL 3-3