SKAARHOJ Eth-SDI Link
Atem2SDI Link Con
fi
guration
Configuration for the Atem2SDI Firmware
IP Con
fi
g
Set the IP address on the web interface of the Atem-SDI Link. In order to access the web interface press
and hold the “config” button on the device, about 10 seconds. The status LED will blink red once and the
serial monitor will report “Config mode”.
Open a browser and enter the web interface by using the base IP address 192.168.10.99. This is the the
default and config IP address of the Atem-SDI Link, even if the IP address was changed for operation
mode.
Press “Submit” to save the settings. Power cycle the device for the changes to take effect.
Con
fi
rm Connection
The serial monitor can be used to confirm if connection have been established between the Atem-SDI
Link and the BMD Atem. The serial monitor will report: Connection to ATEM Switcher establish! followed
by the current camera ccu settings in the atem to be pushed to the cameras.
6
