PLC Instructions
Figure E
To change the block #, move the cursor to the
current block # and use the up/down arrow keys to
select the desired block #. Once the correct block
# is shown, press OK.
The cursor will move to the parameters that can be
changed. Use the right/left arrow keys to move the
cursor to the digit to be changed. Use the up/down
arrow keys to change the number.
3.
Using the up and down keys, navigate through the
screens by moving the cursor. Move the cursor
down to “Start” and press OK. The clock will be
displayed.
4.
If the parameters must be changed, press the ESC
key. The PLC will then show the screen shown in
Figure D
.
Select “Set Param” using the up and down arrow
keys. Press OK.
Once in the Set Parameters mode a screen similar
to
Figure E
will appear.
Figure D
To change the next parameter, press the right arrow
key until the cursor moves to the appropriate location.
Once the parameters are changed, press OK.
Use the up/down arrow key to return to the block #.
If needed, choose another block number and follow
the same instructions to change the parameters.
Once all parameters are set to the desired values,
press ESC. The screen shown in Figure D will
reappear.
To set the clock (if required), move the cursor to “Set
Clock” Use the up/down and left/right arrow keys to
change the time. Press ESC to exit the “Set Clock”
mode.
When
fi nished setting the parameters, press ESC to
return to the normal operating screen. The clock will
be displayed.
For information regarding the
operations of options not listed here,
or servicing questions
please call an SJE-Rhombus
®
customer service technician at
1-800-RHOMBUS
(1-800-746-6287)
Warranty void if panel is modifi ed.
