IndustrialPro™ and MobilityPro™ Gateway
User's Guide
Copyright © 2010 Sixnet LLC. All rights reserved.
30
1.11
– November 2, 2011
Demand scenario is when using the serial port in order to establish a PPP session through a Dial-Up Networking (DUN)
connection.
Unless you are sure the modem should be set to On Demand, the modem should be set to
Always On
.
4.2.2
Testing the connection
Once you've finished entering the settings, and once a connection is established (depending on the connection initiation
behavior described above), navigate to
DIAG (Modem Diagnostic) and click on Refresh button
: the modem’s
WAN IP
should be displayed as outlined in Figure 8. This is the IP address that has been assigned to the modem by the cellular
carrier. At this time, the modem’s WAN light will stay on as long as the connection is maintained.
Notes:
HSPA/EDGE: no activation is required since all the connection and network information is contained in
the SIM card.
HSPA/EDGE: Please note that the modem needs to be reset after a SIM card is inserted.
Please note that some carriers prefer to have the modem phone number hidden. In this case, the
modem phone number is not displayed in BVDM.
Figure 8 – Testing the connection
