background image

 

 

 

SiT-AN6722EB Manual Rev. 2.0 

Page 8 of 8 

www.sitime.com 

 

SiT6722EB Evaluation Board User Manual 

 

Figure A2. SiT6722EB EVB 

 

 

SiTime Corporation

, 5451 Patrick Henry Drive, Santa Clara, CA 95054, USA | 

Phone:

 +1-408-328-4400 | 

Fax:

 +1-408-328-4439

 

© SiTime Corporation,  June 2019. The information contained herein is subject to change at any time without notice. SiTime assumes no responsibility or liability for any 
loss,  damage  or  defect  of  a  Product  which  is  caused  in  whole  or  in  part  by  (i)  use  of  any  circuitry  other  than  circuitry  embodied  in  a  SiTime  product,  (ii)  misuse  or  abuse 
including  static  discharge,  neglect  or  accident,  (iii)  unauthorized  modification  or  repairs  which  have  been  soldered  or  altered  during  assembly  and  are  not  capable  of  being 
tested  by  SiTime  under  its  normal  test  conditions,  or  (iv)  improper  installation,  storage,  handling,  warehousing  or  transportation,  or  (v)  being  subjected  to  unusual  physical, 
thermal, or electrical stress. 
 

Disclaimer: 

SiTime makes no warranty of any kind, express or implied, with regard to this material, and specifically disclaims any and all express or implied warranties, either in 

fact or by operation of law, statutory or otherwise, including the implied warranties of merchantability and fitness for use or a particular purpose, and any implied warranty arising 
from course of dealing or usage of trade, as well as any common-law duties relating to accuracy or lack of negligence, with respect to this material, any SiTime product and any 
product documentation. Products sold by SiTime are not suitable or intended to be used in a life support application or component, to operate nuclear facilities, or in other mission 
critical applications where human life may be involved or at stake. All sales are made conditioned upon compliance with the critical uses policy set forth below. 
 
CRITICAL USE EXCLUSION POLICY 
BUYER  AGREES  NOT  TO  USE  SITIME'S  PRODUCTS  FOR  ANY  APPLICATION  OR  IN  ANY  COMPONENTS  USED  IN  LIFE  SUPPORT  DEVICES  OR  TO  OPERATE  
NUCLEAR FACILITIES OR FOR USE IN OTHER MISSION-CRITICAL APPLICATIONS OR COMPONENTS WHERE HUMAN LIFE OR PROPERTY MAY BE AT STAKE. 
 
SiTime owns all rights, title and interest to the intellectual property related to SiTime's products, including any software, firmware, copyright, patent, or trademark. The sale of 
SiTime  products  does  not  convey  or  imply  any  license  under  patent  or  other  rights.  SiTime  retains  the  copyright  and  trademark  rights  in  all  documents,  catalogs  and  plans 
supplied  pursuant  to  or  ancillary  to  the  sale  of  products  or  services  by  SiTime.  Unless  otherwise  agreed  to  in  writing  by  SiTime,  any  reproduction,  modification,  translation, 
compilation, or representation of this material shall be strictly prohibited. 

Signal 

Probe test 
points 

Содержание SiT6722EB









Отзывы: