Sistemes Electronics Progres Agronic Smart, Руководство пользователя

Страница: 16 / 32

16
· Manual - Agrónic Smart
Stops are controls that act on irrigation programs based on values from the sensors that are
connected to the inputs.
We can configure the following stops:
• Temporary stop: For programs in progress until the
next program start. Any irrigation units left over from
the program will be lost.
Determining factor:
‒ Input 1
‒ Input 2
• Conditional stop: For all programs while the
determining factor in question is active. When it
becomes inactive, the programs will continue from
where they left off.
Determining factor:
‒ Input 1
‒ Input 2
• Detection delay: Applies to both temporary stops
and conditional stops; this is the time that elapses
between the activation of the corresponding input
and the time at which the temporary or conditional
stop takes place.
• Format: Two available time formats: hours/minutes
(hh:mm) or
minutes/seconds (mm:ss).
• Sector meter (Coming soon): If it has a meter, you
must select the input where it will operate:
‒ Input 1
‒ Input 2
• Date and time of controller: Display shows the
time of the controller. If the time displayed is
incorrect, you can synchronise it to the current
time by pressing “update clock”. If you would like
this to occur automatically, activate “automatically
synchronise time”.
• Erasures: You may completely erase:
‒ All programs: erases data from all programs that
are available in the controller.
‒ Entire controller: erases all data entered into the
controller.