Siruba HSM-2722, Инструкция

Страница: 31 / 35

- 30 -
HEMMING (Optional)
1. Raise the foot and the needle to its
highest position. Replace the foot with
the picot foot.
2. Fold over the fabric edge by about 3
mm and place it under the foot.
Secure the folded edge with a few
stitches. Take out the workpiece and
draw the hem into the picot foot
through pulling the threads.
3. Lower the foot and sew the hem.
4. While sewing fold the fabric to the left
a little and allow it to run into the
hemmer foot.
5. Make sure that the fabric does not
move under the right half of the foot.
The fabric must be fed into the scroll
of the hemmer sufficiently so that the
workpiece edge runs freely through
the groove under the foot.
Only suitable materials can be used
and some practice may be necessary
to achieve the best results.
TWIN NEEDLE (Optional)
Put in the twin needle with the flat side backwards.
Thread the machine as for normal
sewing, leading both threads to needle
and passing their ends separately
through its eye.
Sewing width should not exceed the
third widest stitch width, as this will
break the needles.
ATTENTION: When using the twin
needle, adjust the stitch width to
maximally 3. Adjusting the stitch width
to a higher number causes the needle
to break.
3 mm
1 mm
20 mm