C
）調整好後裝回橡膠孔塞。（注：電機兩平面裝的越平越好，如果
兩平面超過
1.5mm
的情況下，電機會比正常安裝的發熱量大和力矩減
小現象。）
Adjusted to fit back rubber hole stopper.(Notes: The distance
between two flat as small as possible, if more than 1.5mm, motor
will be calorific value more and torque decreases.)
（
5
）裝風葉和外殼：
Install Fan and the cover
a)
用手轉動縫紉機，使機針停在最高位，縫紉機手輪如圖
B
Use hand to turn the sewing machine head, let the needle stop in the highest
position
b)
如安裝圖所示將圖⑩風葉裝入並用圖
⑪
螺釘鎖緊
,
（注：停車
針位和風葉與電機間隙如圖
A
、
B
、
C
）
According to the above install picture to install the fan(picture
⑩
), use the
screw(picture
⑪
)to fix.(Attention: the needle stop position and the
clearance of fan and the motor is as following picture A/B/C)
c)
將如安裝圖所示將圖
⑫
塑膠外殼裝入並用圖
⑬
的螺釘鎖緊
According to the above install picture, install the cover(picture
⑫
), and use
the picture
⑬
screw to fix.
d)
將如安裝圖所示將圖
⑭
同步輪罩裝入用圖
⑮
螺釘鎖緊
(
適用於
C007KD
或
S007KD)
According to the above install picture,install the picture
⑭
synchronizing
wheel cover and use picture
⑮
screw to fix.
(apply to C007KD or S007KD)
圖
A
圖
B
圖
C
间隙
1.5
～
2
Clearance
1.5
～
2
感应磁铁
Induct magnet