Siruba ASP-EBJ100, Инструкция

Страница: 27 / 56

A.Band & Band Feeder Position
1. Disconnect the air supply. Loosen the Screw
②
to adjust the distance between Band Locator
①
and Needle
Holder to be 4.5 ~ 5mm.
2. When the band reaches the presser foot, the inner side of the band should align with the Locator
①
. Refer to
Testing Mode to verify the position. Check if there is a gap (less than 0.5mm) between the circled band and
locator
①
.
3. When the Locator
①
pressed and holds the band, the work will be pulled up, causing a breaking thread or poor
sewing. You may need to adjust the Band Feeder position.
4. To adjust the Band Feeder: Loosen 5 screws
③
. Move the Base
④
along with the Inductor
⑤
. After the
adjustment, tighten the 3 screws on the Base
④
. Fix the Rear Board
⑥
of the Band Feeder onto the Base
④
SERVICE & MAINTENANCE

①
②
4.5~5mm
③ ⑥
⑤ ④
P17