Siruba 700K DKKU1, Руководство по эксплуатации, Страница: 12 / 14

故障排除
ERROR CODE & TROUBLE
SHOOTING
序號
The serial
number
錯誤碼
Error
code
錯誤內容
Error content
錯誤問題的多種可能
Several possible error problem
1 Er01
找不到停針位
Can
´
t fi nd the needle
position
1.
手輪靠的不夠近間隙在
2.5mm
內
2.
九針插頭接觸不良
3.
電機霍爾壞，要更換電機
4.
手輪上的磁鐵掉落
1. The hand wheel is not close, clearance within 2.5 mm
2. Nine plug contact undesirable
3. Motor holzer bad, to replace the motor
4. The hand wheel magnet in the loss
2 Er02
開機沒有檢測到調速器
Not detected boot
speed regulator
1.
調速器插頭沒有插
2.
調速器線斷了或接觸不良
1. Speed control device without plug
2. Speed wire is broken or contact undesirable
3 Er03
電機霍爾或相位線錯誤
Motor holzer or phase
error
1.
九針插頭接觸不良
2.
電機沒有安裝好，參照圖
A
3.
霍爾壞
1. Nine hole plug contact undesirable
2. The motor doesn
´
t pack good
3. Holzer is bad
4 Er04
堵轉保護
Locked-rotor protection
1.
電機超載
2.
電機與電控相連接的四心線接觸不好
3.
電機斷線或壞了
1. The motor overload
2. The motor and the controller connected four hole line
contact is not good
3. Motor is bad
5 Er05
硬體過流保護
Hardware over-current
protection
1.
電機超載
2.
信號線接觸不好或斷了
3.
主機板壞了
1. The motor overload
2. Line contact is bad or broken
3. Main board is bad
6 Er07
串口通信逾時錯誤
Serial port
communication
timeout error
顯示幕至主機板信號線不良或主機板壞
Display to the system board signal is bad or board is
bad
7
顯示幕無電開關有電
Screen without electricity
Switch with electricity
1.
主機板壞
2.
顯示幕與主機板連接線接觸不良
1. Main board is broken
2. The display screen and the main board connection
line contact is bad
P9