61 93 556 D3509
39
D3509
.
201.01.02
.
02
19.09.2008
4 Operation
Sirona Dental Systems GmbH
Foot control
Operating Instructions TENEO
Cursor path
The cursor path runs between the pairs of keys, moving from top to bottom
and from left to right, usually in multiple loops. The cursor path can be
traversed between the starting and end points either in a forward or a reverse
direction.
If no further cursor position is available on the touchscreen, the cursor jumps
out of the touchscreen. The cursor path is then continued between the fixed
keys on the EasyTouch control panel.
In Instrument programs, all quick setting keys are selected simultaneously.
This is indicated by a horizontal orange bar located behind the quick setting
keys. The speed or intensity is then set by actuating the 4-way foot switch
plate to the left or right briefly (values on quick setting keys) or for a longer
time (intermediate values), see "Operating the cursor control" [
.
The Clean key, Setup routine and main switch cannot be accessed via the
cursor control.
Orange and blue bars
A blue bar indicates which functions are assigned with the left or right button
of the foot control. For example, the mouth rinsing position (S) and entry/exit
position (0) chair programs are assigned in the Start program, while the Spray
and Chip blower are assigned in the Instrument program.
If the cursor control
without
program change is activated, the blue bars also
can be selected with the cursor. If the cursor control
with
program change is
activated, the blue bars are skipped for faster navigation.
Chip blower key in the Instrument program
When the cursor control is activated, the instrument program will display the
Chipblow
er
key.
4.3.3.2
Operating the cursor control
Moving the cursor
¾
Briefly slide the 4-way foot switch plate upward or downward.
ª
The orange cursor moves forward or back one cursor position.
¾
Hold the 4-way foot switch plate up or down (auto cursor).
ª
The orange cursor slowly moves from one cursor position to another.
S
0
S
0
S
0
S
0
