Sirona ORTHOPHOS XG 3 DS, Руководство по обслуживанию

Страница: 524 / 578

59 38 399 D3352
6 – 92
D3352.076.01.13.02 07.2008
6.21 Replacing cables Tabs 6
6.21.1 Laying the cable conduit on the rotating
element
(applicable to cables L3, L5, L6, L11 and L12)
CAUTION
The connectors and cables must be protected by inserting them in the fabric
tube supplied with the cables.
Preparations
z
Remove the covers.
z
Pull the connectors off of board DX6.
z
For L12: Protect the tongue of connector RJ45 by wrapping it with insulat-
ing tape. Make sure that the contacts don't get sticky or stuck together!
z
For L3: Remove the connector of the cable with tool W1 .
z
Pull off the flexible tube and the spiral spring.
z
Remove the defective cable and run the new cable up to the rotary ring in
the original position.
z
Use insulating tape to fasten the end of the grounding strap to cable L12.
1. Bunch the cables together to form a loom. Fasten the defective cable to
the loom and use it as a pull wire to pull the loom through the fabric tube
(A) . Pull the fabric tube over the connector and as far over the cable look
as possible.
2. Use the pull wire to pull the fabric tube into the spiral spring.
1.
2.
W1
A