4
CHAP. 1 - INFORMATION ABOUT THE APPLIANCE
1.1 - GENERAL WARNINGS
•
The appliance must only be used by personnel who has carefully studied this
manual and understood all the safety standards described herein.
•
If there should be a turnover in personnel, it is necessary that this manual is
carefully studied before using the appliance.
•
Before cleaning or servicing the appliance, disconnect the electricity power
supply.
•
When cleaning or servicing the appliance (safety protections removed) take
into consideration all possible hazards- Residual Risks.
•
When servicing or cleaning the appliance always concentrate on what you are
doing and avoid any possible distractions.
•
Check the electricity power cable on a regular basis; a worn or damaged cable
causes a dangerous electrical hazard.
•
If the appliance has a presumed malfunction or does not work correctly, do not
use it or repair it. Contact the “Service Centre”. Details given on back page.
•
Do not use this appliance for frozen food products, meat and fish with bones
and non-food products.
•
Do not put your fingers into the appliance when working.
•
The manufacturer cannot be held responsible for the following situations:
⇒
if the appliance or safety devices are tampered with by unauthorised personnel
⇒
if non original
spare parts are used;
⇒
if the instructions given in this manual are not carefully and correctly
followed or respected;
⇒
if unsuitable cleaning products are used to clean the appliance.
1.2 - SAFETY FEATURES INSTALLED
1.2.1 - mechanical safety features
Regarding the mechanical safety featrures the appliance described herein
conforms with the EU directives EEC 89/392 and EEC 91/368, 92/31, 93/44,
93/68.
These protections are (refer to 1.3.3):
- outlet protective cover;
- food inlet;
- pestle.
1.2.2 - electrical safety features
Regarding electrical safety features, this appliance conforms to the EU directives
EEC 73/23, 89/336, EEC 91/368, 92/31, 93/44, 93/68 and to standards EEC EN
60335-1, EN 55014.
13
FIG. n°11 - Mounting and removing disks
5.3 - MOUNTING AND REMOVING CUTTER DISKS (see FIG. n°11)
CAUTION
: When mounting the cutter disks carefully follow the below instruc-
tions:
1. raise the protection (1);
2. unscrew the wing nut (2) that secures the disk onto (3) the motor shaft;
3. change disks and then invert the procedure to secure the new disk into posi-
tion.
3
1
2
2
1
3
FIG. n°9 -Filling
FIG. n°10 - Correct position
