Sirius Satellite Radio SUPV1C Plug & Play, Руководство пользователя и инструкция по установке, Страница: 28 / 44

[
Installation
]
2
existing wiring harness.
Route the cable through the main cabin area under the interior trim, towards the
front of the vehicle. Use a plastic putty knife to lift the plastic trim just enough to
tuck the cable under underneath. Avoid side airbag locations on back pillars and
above the doors. (Airbag locations are marked with “SRS” logos.) Be careful not
to crimp or cut the cable.
Bring the cable out from the trim near the firewall and route it under the carpet
toward the dashboard or console. Coil any excess cable in a hidden location,
such as under the carpet, keeping it away from any vehicle pedals or controls.
Secure the excess cable with wire ties.
Bring the end of the cable out at the SIRIUS radio location. Leave yourself
enough cable so you can easily connect it to the antenna connector of the
SIRIUS radio or vehicle dock.
Connecting the Cigarette Lighter Adapter
Connect the provided cigarette lighter adapter to the
DC5V
connection at the rear of
the vehicle dock. (Refer to Figure 1 on page 10 for the location of this connector.)
Docking the SIRIUS Radio
If your radio is a SIRIUS Plug and Play series ST or SV, you will need to install the ve-
hicle dock adapter provided with the kit. Refer to Figure 17 and place the vehicle dock
lock in the unlocked position (1). Install the adapter into the front of the vehicle dock,
positioning it behind the connector and against the backrest (2). Once the adapter is
installed in the vehicle dock, slide the lock to the locked position (3). The radio may
now be placed into the vehicle dock, pressing the radio down until it is fully seated.
3.
4.
5.