Sirius Satellite Radio SL906 L 1500, Инструкции по установке, использованию и обслуживанию

Страница: 7 / 16

7
INSTALLATION
Before installing the appliance, make sure that
none of the parts is damaged in any way.
In case of damaged parts, contact your retailer
and do not proceed with installation.
Read all of the following instructions with care be-
fore installing the appliance.
- Before installing the appliance, remove the me-
tal grease filter. This filter can be removed by pu-
shing the handles towards the back side of the
cooker hood and turning it downwards to unfa-
sten it from its slot. (Pic. 3).
To install the appliance please respect the fol-
lowing instructions.
The appliance must be installed by competent
authorities. In order not to damage the electronic
parts of the appliance please do not use additio-
nal screws.
Essential precautions to respect before installing
the appliance are the following:
- Prepare the power supply.
- Prepare a hole for the exhaust of the air both in
the filtering and in the exhausting version.
- Use an exhausting pipe whose maximum length
does not exceed 5 meters.
- Do not use screws to fix the outlet pipe to the
cooker hood.
- Limit the no. of elbows in the piping, since each
elbow reduces the aspiration efficiency of 1 linear
meter. (Ex.: if you use no. 2 x90 ° elbows, the
length of piping must not exceed 3 meters)
- Avoid abrupt direction changes.
- Use a 200 mm or 300 mm constant diameter
pipe for the whole length.
- Use piping approved by standards in force.
- In the units equipped with 2 motors please use
a 200mm constant diameter pipe for the whole
length.
In the units with 3 motors please use a 300mm
constant diameter pipe for the whole lenght.
Please be sure to have made a cut-out on the
bottom of the cabinet which is suitable to hold the
appliance in position (Fig. 4).
SL906L 1500 1480x364mm
SL920L 856 821X505mm
SL920L 1200 1165X505mm
SL920L 1500 1470X505mm
At this point, insert the range hood inside the
kitchen cabinet until the fixed springs will be ho-
oked into.
When the hood will be positioned into the cabinet,
it’s important to fix the appliance according to the
following instructions.
Unscrew by 180° the horizontal screws as shown
in fig. 5, during this operation it is necessary to
support the hood with your hand (fig. 5).
Screw the vertical screws so that the hood is
adherent to the cabinet.
Repeat this operation for all four screws.
If it is necessary, it’s possible to put other screws
along the front or rear of the product as shown in
picture 7.
Warning: according to the model you have pur-
chased, please read the “maintenance” chapter
to check whether the light has to be removed
when installing the screws.
Make the electrical connection and connect the
air outlet pipe.
Warning!
Before connecting the flexible exhausting pipe to
the motor, make sure that the stop valve, which is
on the air outlet of the motor, can swing.
Exhausting version
Connect the flange to the exhausting hole with an
appropriate pipe. Connect the appliance with the
electrical mains through the supply cord.
Filtering version
Connect the flange with a pipe suitable to con-
vey the air to the top of the cabinet. Connect the
appliance with the electrical mains through the
supply cord.