Sirius Satellite Radio SEM11, Руководство по установке, Страница: 10 / 16

10
The SEM71 motor is designed to exhaust fumes and
odours silently and effectively. It must be installed on an
external wall a minimum of 500mm from the ground and
connected to the rangehood.
Note: due to OH&S regulations if the SEM71 motor
is positioned higher than 2 metres from the ground,
additional servicing costs may incur. Please note,
motor must be accessible for servicing.
Note: due to the noise of the motor itself once installed, be
sure to check that if it is located close to a boundary fence
or you are in a built up area that you have checked with
neighbours or local council regulations prior to installation.
• Note: the SEM71 motor cannot be installed
back-to-back with the rangehood.
Motor/ducting and electrical connection installation
• Please note that the SEM71 motor must be installed at
a minimum distance of 2 metres from the outlet collar
on the rangehood. A maximum of 7 metres must not
under any circumstances be exceeded. All SEM71
motors come fitted with a 7metre long control cable.
1. The installation of the SEM71 motor must only be
made by a qualified technicial/tradesperson. Where
possible use a Sirius recommended installer. (See
www.siriusbrand.com for a list under the support tab)
2. After predetermining the location of the motor, make
sure you are within the recommendations above in
regards to min/max distances. Use the supplied drill
hole template that is supplied with the SEM71 motor
and drill support holes, paying careful attention to
make sure that the area behind is clear of electrical
cables and/or piping & plumbing. These holes are to
be drilled with an 8mm drill bit.
3. 210mm diameter hole to be cut into house for 200mm
ducting. Please note that if a solid masonary block wall
or brick wall is being used thaty a series of holes may
need to be drilled and then the remainder of the hole
be knock out by hand with a hammer and chisel. If a
masonary hole bit is available, this will provise the best
result.
4. A hole must also be made to contain the plastic pipe
that the SEM71 wiring loom is fed through. 40mm hole
is required. 40mm drill bit required.
5. Remove the stainless steel body to expose the motor
and fixing points by removing the external screws
located on the outside of the SEM71 motor. (Fig.4)
6. Run the length of semi-rigid/solid duct through the
pre-cut and attach to the SEM71 collar. Secure in
place with a URC-25/215 ring clamp, making sure it is
fastened tightly and will not come off. Feed the cable
from the motor though the 40mm plastic pipe at the
same time.
7. Lining up the fastening points with the pre-drilled holes
secure the motor in place using the supplied plastic
dowels and the supplied screws.
8. Replace the stainless steel body by following the
step 5 in reverse making sure that the holes line up
perfectly to ensure the unit is sealed correctly.
Do not
silicone motor to the wall.
9. Run the length of ducting back to the location of
the rangehood and secure to the outlet collar on the
rangehood using anouther URC25-215 ring clamp.
10. The SEM motor has a 7 metre long cable with
colour-coded wiring. Follow the MOTOR WIRING
CONNECTION instructions on page 4 of this manual
to connect the motor to the rangehood.
11. The SEM71 motor will draw power directly from the
rangehood which needs to be plugged into a 10AMP
powerpoint located within 1 metre of the rangehood.
SEM71 MOTOR
A
A
A
A
B
Screws
B
B
B
B
210mm
40mm
A
(Fig. 3)
(Fig. 4)
For full details, refer to installation template on page 11.