Sirius Satellite Radio SC-H1W, Руководство пользователя, Страница: 61 / 68

SIRIUS LCD Wireless Controller 55
Troubleshooting
PROBLEM: I’m only receiving channels 000 and 184.
SOLUTION: Call 1-888-539-7474 to activate your subscription.
PROBLEM: The LCD continues to display "Antenna Not Detected."
SOLUTION: Make sure your antenna is securely connected to the radio.
PROBLEM: The remote doesn't show any information after pressing SIRIUS.
SOLUTION: Press the Reset button on the radio.
PROBLEM: I've added a second radio but the remote can't find it after pressing
SWAP .
SOLUTION: Press the Reset button on the Conductor radio.
PROBLEM: My audio receiver doesn't respond to any of the codes.
SOLUTION: Program your SIRIUS wireless controller to learn the functions from
your original remote (See “Using Learning” on page 20.).
PROBLEM: I cannot get the audio source Input function to switch automatically
when I press
SIRIUS .
SOLUTION: Use your SIRIUS wireless controller’s learning feature to learn the
Audio Receiver's Input function to a numeric button (
0-9 ) in Receiver
mode, then go through Audio Source Programming again.
PROBLEM: I get an Out of Range message even when I’m close to the radio.
SOLUTION: Go through Sirius Setup and delete the radio, then add the radio to
the remote again.
PROBLEM: I can't get all the functions working properly for my AV device (TV,
Receiver, Cable Box, etc.).
SOLUTION: Some codes work only partial functions. Try going through the
remaining codes in the list to find one that works better. If you can't
find any, then learn the missing functions to the remote.
PROBLEM: No display at all times.
SOLUTION: Replace batteries with four new AAA alkaline batteries.
PROBLEM: No display when programming.
SOLUTION: Display has turned off due to inactivity. Start programming again and
do not pause while performing instructions.
PROBLEM: During programming, the LED displays a long flash.
SOLUTION: An invalid entry has occurred. Check the keys to be pressed and start
program again.
PROBLEM: How do I stop programming?
SOLUTION: Press SET once to back up one step in programming. Press and hold
SET to exit programming completely.
PROBLEM: Changing channels does not work properly.
SOLUTION: If the original remote control required pressing ENTER to change
channels, then press ENTER on the remote control after entering
channel numbers.
PROBLEM: No remote control of volume.
SOLUTION: See “Setting Volume Control” on page 23 to lock/unlock volume.
PROBLEM: Cannot program my combo device code
SOLUTION: Make sure have selected the correct device key for your combo code.
SIRIUSRadio.book Page 55 Tuesday, November 21, 2006 5:15 PM