TI03-328ENG-REV5
7 of 12
OPERATION
To better understand how the FX10 Series Units can be fully
utilized in the examination of forensic evidence, we suggest
you first perform the following procedure of comparing a latent
print lift to a print on a 10-print fingerprint card (see Figure
1). These step-by-step instructions cover every aspect you may
encounter in the examination. For the purpose of this examina-
tion, set the Focusing Jacks midway between upper and lower
extremes—this is the focus point for two-dimensional objects
(latent lift, 10-print card, document, etc.) which allows the im-
age to remain in focus throughout the entire Zoom range.
Note:
When examining three-dimensional objects, the jacks will need
to be lowered accordingly.
1. Plug the unit’s AC power cord into a convenient outlet and plug the TV
monitor into the back of the unit. Then, connect the Video Output from
the unit to the appropriate Video IN connector on back of monitor.
2. Place a latent print on the left Focusing Jack (Channel A). Place a 10-print
record card on the right Focusing Jack (Channel B). Adjust both jacks to
the mid-range height.
3. Switch all three switches on the Lower Front Control Panel to ON.
4. Switch the Upper Control Panel Power Switch to ON. Press the CAM A
switch and center the latent print under the lens (see Figure 2). Zoom to
full image size with the Channel A Zoom Control. Adjust Channel A Fo-
cusing Jack for sharpest focus.
FIGURE 1
FIGURE 2
FIGURE 3