Siqura FD820M1IR, Руководство по установке

Страница: 14 / 39

Connector Pin No. Definition Remarks
Reset button - Press this button for at least 10 seconds to restore the
system to its factory-default settings (including network
settings).
BNC - Analogue video output
Alarm I/O 1 Alarm connection
2 Output -
3 Input +
4 Input -
Audio I/O 1 Input Two-way audio transmission
2 GND
3 Output (R)
4 Output (L)
Power DC 12
V 1 Power Power connection
2 Reserved
3 GND
AC 24 V 1 Power-1
2 Earth GND
3 Power-2
RJ-45 - 10/100 Mbps Ethernet / PoE
4.2 Power the camera
Connect the power jack to the FD820 before plugging it into a power socket to avoid danger of
electric shock. Note that the supplied DC power adapter is for indoor use only.
If you use PoE (Power over Ethernet), make sure PoE equipment is in use on the network.
Important: The FD820M1 must use 12 Vdc or 24 Vac for operation below -30°C. The
FD820M1IR and FD820M1IRMP5 must use 12 Vdc or 24 Vac for operation below -10°C.
Using PoE or a power supply, the fan is on whenever the heater is enabled. Power
consumption is 5.5W; 12W with heater/fan (+3.6W for IR option).
4.3 Connect to network
Category 5 Ethernet cable is recommended for network connections. For the best transmission
quality, do not exceed a cable length of 100 metres.
To connect through a hub or switch
● Connect one end of a straight through Cat 5 cable to the RJ-45 connector of the IP camera
and the other end of the cable to the hub or switch.
Connectors and cabling
14