Sipura 2000 - FAQ
1. How do I find/set the IP of the device?
Connect analog phone to RJ-45 connector on SPA-2000. On telephone keypad,
enter star key four(4) times: ****. When you hear an IVR enter the code as shown
in following table.
SPA-2000 MENU OPTIONS
Action
Code User Input
Behavior Notes
Enter IVR Menu
**** None
Ignore SIT or other tones
until you hear, “Sipura
configuration menu. Please
enter option followed by the
pound (#) key, or hang up to
exit.”
Check DHCP
100
None
IVR will announce if DHCP is
enabled or disabled.
Set DHCP
101
Enter 1 to enable.
Enter 0 to disable.
Enter option followed by the
pound (#) key.
Check IP address
110 None
Set IP Address
111
Enter value using the
numbers on the telephone
keypad. Use the star (*)
key when entering a
decimal point.
Enter value followed by the
pound (#) key. DHCP must
be “Disabled,” otherwise; you
will hear the message,
“Invalid Option” if you try to
set this value.
Check Net Mask
120 None
Set Net Mask
121
Enter value using the
numbers on the telephone
keypad. Use the star (*)
key when entering a
decimal point.
Enter value followed by the
pound (#) key. DHCP must
be “Disabled,” otherwise; you
will hear the message,
“Invalid Option” if you try to
set this value.
Check Gateway
130 None
Set Gateway
131
Enter value using the
numbers on the telephone
keypad. Use the star (*)
key when entering a
decimal point.
Enter value followed by the
pound (#) key. DHCP must
be “Disabled,” otherwise; you
will hear the message,
“Invalid Option” if you try to
set this value.
SPA-2000Menu Options
2. When I attempt to make a call using SPA2000 device, I get dead air?
Make sure your device is pingable. Also if you have tried to change the
configuration on your device recently, use configuration guide provided by
Net2phone to change to the working configuration.
