6
TECHNICAL SPECIFICATIONS
GUARANTEE
This SIP electronic headshield is covered by a 12 month parts and labour warranty
covering failure due to manufacturers defects. This does not cover failure due to mis-
use or operating the electronic headshield outside the scope of this manual - any
claims deemed to be outside the scope of the warranty may be subject to charges
Including, but not limited to parts, labour and carriage costs.
This guarantee does not cover spatter damage and consumables such as the bat-
tery, inner and outer cover lenses etc.
In the unlikely event of warranty claims, contact your distributor as soon as possible.
Note:
Proof of purchase will be required before any warranty can be hon-
oured.
Part Number
02884
02886
02889
Model
Meteor 2300
Meteor 2300F
Meteor 2300LE
Filter Size
133mm x 114mm x 10mm
Viewing Area
100mm x 59.5mm
Outer Protection Lens
134 x 114
Inner Protection Lens
105 x 66
Grind Light State
Shade 4
Cut Dark State
Shade 5 - 9
Weld Dark State
Shade 9 - 13
Power Supply
Lithium Battery & Solar Cells
Battery Type
CR2450
Operating Temperature Range
-20°C to +65°C (-4°F to 149°F)
Switch Time
1/10000S
Delay Time
0.1 - 0.8 seconds
Net Weight
0.5 Kg
11
MAINTENANCE INSTRUCTIONS
Inspection:
Carefully inspect your electronic headshield regularly.
Cracked, pitted or scratched filter or cover lenses reduce vision and seriously im-
pair protection.
These should be replaced immediately to avoid damage to the eyes.
Inspect the complete helmet frequently and replace worn or damaged parts im-
mediately.
Cleaning:
Clean the helmet with mild soap and lukewarm water.
Clean the welding filter with a clean lint free tissue or cloth; Do not immerse in wa-
ter.
Do not use solvents.
Replacing the rear cover lens:
From inside the helmet, remove the screw on the filter holder.
Push the 2 tabs outwards and lift the filter holder up.
Remove the filter lens.
Slide out the old cover lens.
Pull off the plastic protection film and slide in the new cover lens.
Follow the above instructions in reverse to refit the filter lens etc.
Replacing the front cover lens:
From inside the helmet, remove the screw on the filter holder.
Push the 2 tabs outwards and lift the filter holder up.
Remove the filter lens.
Pull out the old cover lens.
Pull off the plastic protection film and put the new cover lens back in.
Follow the above instructions in reverse to refit the filter lens etc.
Note:
Do not use the helmet without the cover lenses in place.
Replacing the batteries:
From inside the helmet, remove the screw on the filter holder.
Push the 2 tabs outwards and lift the filter holder up.
Slide the battery compartment down and remove.