14
OPERATING INSTRUCTIONS….cont
To Fuel / re-fuel the pressure washer:
1. Remove the fuel cap.
2. Carefully pour the petrol into the tank to the desired level and refit the fuel cap.
3. Remove any spilt fuel from the pressure washer and surrounding area to avoid any
risk of fire.
FITTING / CHANGING NOZZLES
Note: Never
overfill the fuel tank; leave a small air gap at the top
.
Fuel capacity: Approx. 3.6 Litres.
Note:
When re-fuelling always ensure that the fuel filter (supplied) is in place
under the filler cap, as foreign matter or debris will cause damage to the
engine and greatly reduce the life of the pressure washer.
Fuel Cap
Fuel Filter
The low pressure (black) nozzle should be fitted to when starting the engine.
Lance
Quick Coupler
Nozzle
Note:
Ensure that the trigger is in the “off” position when changing nozzles.
15
OPERATING INSTRUCTIONS….cont
Pull back on the quick coupler connection at the end of the lance (see below, left).
Push the nozzle into the quick coupler connection and allow the connector to spring
back; This will hold the nozzle in position (below, right).
Once the engine is running, follow these instructions to fit the required nozzle.
STARTING THE ENGINE
Choke
Fuel Tap
Familiarize yourself with the main controls for starting the engine (above).
Note: Always
fit the low pressure (black) nozzle and hold the pistols trigger
‘open’
every time
the engine is started; This will ensure that the operator is
not trying to start the engine against back pressure.
