SIP 08909, Руководство пользователя

Страница: 8 / 16

15
PARTS IDENTIFICATION
Refer to  gs. 1, 2 and 3.
1
Main ON/OFF switch
2 Lifting and transport handle
3
Left safety hook
4 Warning plate. It informs of residual risks; it is
forbidden to use the machine without having read
the instruction manual  rst; it is forbidden to use
the machine to wash people, animals, electrical
equipment or the high pressure cleaner itself
5
Identi  cation nameplate. It bears the serial number
and the main technical speci  cations
6 Electrical power supply cable
7
Right safety hook
8
Release button
9 Wall-mounting frame securing screw
10
Check ring
11 Wall-mounting frame
12 Hose reel
13
Wall-mounted accessory frame
14 Wall-mounted frame securing wall-plug (orange)
15
Hose reel handle
16
Wall-mounted frame securing nut
17 Pump water inlet  tting
18 Water inlet  lter
19 Foam spray nozzle
20
Detergent suction adjustment device
21 Detergent  ask
22
High pressure gun lever
23
High pressure gun lever safety lock
24 High pressure gun
25
Water inlet quick-release  tting
26 Water inlet hose holder gasket
27
Water inlet hose holder bend
28
Spray nozzle pipe
29 Rotating spray nozzle pipe
30
Nozzle holder head
31 Nozzle cleaning pin
32 Nozzle disassembly key
33
Rotating high pressure cleaning brush
34 High pressure hose
35
Handle securing screw (length 2 cm/0.8”)
36
Wall-mounted accessory frame securing screw
(length 4 cm/1.6”)
37 Wall-mounted accessory frame securing wall-
plug (grey)
SAFETY DEVICES
• Thermal protection.
This device stops the high pressure water cleaner if the electric motor overheats. If this
occurs, proceed as follows:
- Place the master switch (1) in position “0” and disconnect the plug from the wall socket;
- Press lever (22) of the gun to discharge possible residual pressure;
- Wait 10-15 minutes to allow the high-pressure cleaner to cool;
- Check that the requirement for the mains power connections have been respected (see
the INSTRUCTION MANUAL - SAFETY WARNINGS ), paying particular attention if an extension
lead is used;
- Reconnect the plug and repeat the start procedure described at paragraph “OPERATION” .
• Pressure restriction/adjustment valve.
This valve that is calibrated by the manufacturer, which allows the fluid pumped to return to
the suction line of the pump, which avoids dangerous pressures when the high pressure
water gun is shut-off or when attempting to set pressures above the admitted values.
• Gun lever blocking device.
This safety catch (23) allows to block the lever (22) of the gun (24) in the closed position,
preventing accidental
activation (Fig. 2, position S).